FREE SHIPPING ON US ORDERS OVER $250

RF Design RFD868X Ultra Long Range Radio Modem

$88.40
RF Design RFD868X Ultra Long Range Radio Modem featuring
  • Long-range >40km depending on antennas and GCS setup
  • 2 x RP-SMA RF connectors, diversity switched.
  • 1 Watt (+30dBm) TX power.
  • TX low pass filter.
  • > 20dB Low noise amplifier, high IP3.
  • RX SAW filter.
  • All I/O ESD protected and filtered.
  • SiK and Multipoint SiK firmware, field upgradeable, easy to configure.
  • Small and lightweight.
  • License free use in Australia, Canada, USA, NZ
OR
  • DESCRIPTION
  • SPECIFICATIONS
  • SUPPORT
  • REVIEWS
  • Features

    • Long-range >40km depending on antennas and GCS setup (80km demonstrated by Edge Research labs on a balloon, 57km in India, on Dipoles).
    • 2 x RP-SMA RF connectors, diversity switched.
    • 1 Watt (+30dBm) transmit power.
    • Transmit low pass filter.
    • > 20dB Low noise amplifier, high IP3.
    • RX SAW filter.
    • All I/O ESD protected and filtered.
    • Re-implemented SiK and Multipoint SiK firmware, field upgradeable, easy to configure.
    • Small and lightweight.
    • License-free use in Australia, Canada, USA, NZ
    • Note: Not compatible with older modems (RFD868+)

    Interfaces

    • RF: 2 x RP-SMA connectors
    • Serial: Logic level TTL (+3.3v)
    • Power: +5v, ~800mA max peak (at maximum transmit power)
    • GPIO: 6 General purpose IO (Digital, ADC, PWM capable). 

    Specifications

    • Frequency Range:  868 - 869 MHz
    • Frequency-hopping spread spectrum (FHSS)
    • Output Power: 1W (+30dBm), controllable in 1dB steps ( +/- 1dB @=20dBm typical )
    • Air Data transfer rates: 4, 8, 16, 19, 24, 32, 48, 64, 96, 128, 192 and 250, 500 kbit/sec ( User selectable, 64k default )
    • UART data transfer rates: 9600, 19200, 38400, 57600, 115200, 400k, 921k baud  ( User selectable, 57600 default )
    • Output Power: 1W (+30dBm)
    • Receive Sensitivity: >121 dBm at low data rates, high data rates (TBA)
    • Size: 30 mm (wide) x 57 mm (long) x 12.8 mm (thick) - Including RF Shield, Heatsink and connector extremeties
    • Weight: 14.5g
    • Mounting: 3 x M2.5 screws, 3 x header pin solder points
    • Power Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800 mA peak at maximum power
    • Temp. Range: -40 to +85 deg C, tested operational from -73 to +123 deg C.

    Software/GCS Support

    • The software solution is an open-source development called "SiK".  It has been re-implemented to suit the new processor architecture available on the 32bit ARM processor core.  A boot loader and interface is available for further development and field upgrade of the modem firmware via the serial port.
    • Most parameters are configurable via AT commands, Eg. baud rate (air/UART), frequency band, power levels.
    • Integrated support for configuring the RFD900 radios is supported by Mission Planner.
    • Transparent serial link
    • Point to Point, or Multipoint networking
    • Configuration by simple AT commands for local radio, RT commands for remote radio
    • User-configurable serial data rates and air datarates
    • Error correction routines, Mavlink protocol framing (user selectable)
    • Mavlink radio status reporting (Local RSSI, Remote RSSI, Local Noise, Remote Noise)
    • Automatic antenna diversity switching on a packet basis in realtime
    • Automatic duty cycle throttling based on radio temperature to avoid overheating 

                  Manuals and Documentation

                  Compliance

                  The modem is designed for system integrators who will integrate the modem into their own projects and product prototypes.  The user is responsible for compliance with local regulations for radio transmitters.